RJ11 Airburst Cue Strip
- $14.99
This cue strip is designed to allow your module to fire Airbursts. Airbursts typically come as a set of three effects, pre-wired into an RJ11 harness. Each kit includes one cue strip with two separate RJ11 female connectors.
The first connector replaces the first three cues in the bay. The 2nd connector replaces the second three cues in the bay. For example, cues 1-3 and cues 4-6 in the first bay, cues 7-9 and cues 10-12 in the second bay, or cues 13-15 and 16-18 in the third bay.
You can install one or more cue strips per module. If you are using a Slat Connector, you will only be able to install these cue strips in the first and second bays. Installation is simple, only a screwdriver is required.
For wiring / pin-out information, please refer to our Pinout Mapping below.
Can the airburst cue strip replace any of the existing cue strips?
Yes, This cue strip can replace any and all cue strips.
Can you install 3 cues strips in one module?
Yes, unless the slat connector is being used, then the maximum is two in the 1-6 and 7-12 cue bays.
Is this product compatible with the slat connector?
Yes, however when using a slat connector, you will only be able to install a maxiumum of two airburst cue strips in the 1-6 and 7-12 cue bays.
Is there a pin-out available for custom applications?
Yes, please see the Pin-out Mapping tab above.